五月伊人婷婷-五月伊人网-五月在线观看-五月中文字幕-五月综合激情-五月综合激情久久婷婷

Branding

How to operate a flatbed semi trailer after purchase?

TITAN VEHICLE | 2020-04-15
How to operate a flatbed semi trailer after purchase?

 

Connection and separation operation of flatbed semi trailer and truck head

 

1> Connection operation:

1. In order to connect the traction pin and the traction seat smoothly, the semi trailer should be in a state of air outage.

2. Lift the outriggers so that the semi trailer traction pin seat plate is about 10-13 mm lower than the center position of the traction seat of the truck.

3. Open the unlocking lever of the traction seat on the truck and open the traction locking mechanism.

4. Turn the truck backwards so that the semi trailer traction pin is guided into the opening of the locking mechanism through the V-shaped opening of the traction seat and pushes the locking block to rotate and lock the traction pin.

5. Connect the gas path. open the semi trailer connection disconnect switch on the truck head to make the trailer get enough air pressure.

6. Connect the circuit and insert the wire connection plug of the truck head into the wire socket of the semi trailer.

7. Operate the lifting leg correctly to retract it, then pull down the handle and hang it on the hook.

flatbed semi trailer customer feedback

TITAN flatbed semi trailer African customer feedback

 

2> Separation operation:

1. Try to choose a flat and solid ground to separate the semi-trailer and the truck head. If the foundation is soft or the asphalt road is separated in summer, a thick wooden board should be placed under the base of the lifting leg to prevent the situation of reconnection due to sinking load.

2. Operate the lifting leg so that the base of the lifting leg is on the ground, then change the low gear and lift the semi-trailer with some clearance to exit the truck head.

3. Disconnect the plug from the semi trailer wire connection socket.

4. Turn off the flatbed semi-trailer air connection disconnect switch on the truck head, and then change the low speed position to remove the tractor’s air connector from the semi trailer.

5. Pull out the traction seat to unlock the lever, so that the locking block is opened.

6. Drive the tractor slowly forward to disengage the traction pin from the traction seat to separate the semi-trailer and the tractor.

7. After separation, check all parts of the semi trailer for abnormalities, and unscrew the drain valve at the lower part of the gas cylinder to drain the water in the cylinder.

 

3 axle flatbed semi trailer

TITAN 3 axle flatbed semi trailer for sale

 

Operation about driving flatbed semi trailer

 

1> Inspection before starting

Whether the tire pressure of the truck head and semi trailer is a predetermined value.

Start the engine and observe the barometer in the cab.

Push the handbrake of the tractor, you can hear the obvious rapid deflation sound, see the brake air chamber push rod retracted, and release the parking brake.

Check for air leakage in the air circuit and whether the braking system works normally.

 

Check whether the gas lamps are working properly and whether the electrical connections are well connected.

 

2> Getting started

After all inspections are determined to be normal, continue to make the brake system air pressure rise, and then start smoothly according to the operating requirements of the truck head, and check that the braking of the entire vehicle is reliable.

 

3> During driving

Prevent the semi-hanging braking system from being used for a long time to avoid the brake system pressure being too low and the emergency relay valve to brake the wheels automatically.

To prevent the brake drum from overheating on long or steep slopes, use the truck head engine braking device to brake as much as possible.

Pay attention to the height limit signs on the roads to avoid collision with the devices on the roads.

 

Loading containers

Before the high bed semi trailer are loaded into the container, the used turn lock head should be completely overlapped with the lock seat and fixed. Then the container is correctly placed on the semi trailer, and then the turn lock handle is turned lock the container vertically with the lock head and the lock seat.

Before unloading the container, the turn lock should be turned to the position where the lock head overlaps with the lock seat and fixed, and the container can be removed only after it is confirmed that the container is not locked.

 

If you want more information about our semi-trailer, please click “Flatbed Semi Trailer“. 

 

And you can also look at other resources and products on our website.

 

Click "Flatbed Trailer" to get more videos.

Feedback

whatsapp
亚洲夜色噜噜av在线观看| 免费看撕开奶罩揉吮奶头视频| 欧美性欧美巨大黑白大战| 中文字幕av一区二区三区人妻少妇| 国产精品黄在线观看免费软件| 欧美群交射精内射颜射潮喷| 国产成人综合91香蕉| 一 级做人爱全视频在线看| 亚洲乱码日产精品bd| 亚洲av无码专区在线电影| 手机福利视频| 亚洲精品成av人片天堂无码| 国产精品99久久久久久人| 超pen个人视频国产免费观看| 亚洲精品无码人妻无码| 天天做日日做天天添天天欢公交车 | 国产男女无遮挡猛进猛出| 日本japanese丰满少妇| 精品久久久久久婷婷| 99精品国产在热久久无码| 成人午夜视频免费| 国产情侣一区二区| 国内揄拍国产精品人妻门事件| 日韩性爱视频| 久久免费的精品国产v∧| 国产精品久久久久久久久福利| 特黄三级又爽又粗又大| 熟女人妻少妇精品视频| 国产裸拍裸体视频在线观看| 99久久精品免费观看国产 | 欧洲精品免费一区二区三区| 亚洲av永久无码精品古装片| 无码人妻av一二区二区三区| 搡老女人老妇老熟女hd | 欧美jizzhd精品欧美| 亚洲精品综合一区二区| 欧美疯狂性受xxxxx喷水| 亚洲一区二区三区四区五区六区 | аⅴ资源天堂资源库在线| 午夜dv内射一区区| 国产高清在线精品一区|